Transformation

Transformation

1. Which type of LB plate is required? Which traits do we want in the transformants? Create LB plates with the appropriate antibiotic, as well as IPTG and X-gal if you are using blue/white screening. If you are doing a low number of transformants, these chemicals can be added directly to normal LB plates, with beads to spread out the chemicals. Wait at least one hour for the chemicals (antibiotics and possibly IPTG + X-gal) to diffuse into the plates.
2. Turn on heat block to 42 degrees.
3. Turn on shaking water bath to 37 degrees.
4. Spray a beaker with ethanol, go get ice from the second floor imaging room (across from lab).
5. Label 1 1.5mL microfuge tube for each of your experimental groups. (3 tubes for pUC18, pUC18-Empty, water 1 Control). From the -80 freezer: get enough competent cells to transfer 250 uL cells in each of the previously labeled experimental group tubes. Each freezer tube has 100uL cells. For negative control (water) you can use 100uL cells.
6. Transfer 250uL of bacterial cells to each of your ligated and empty plasmid microfuge tubes. Transfer 100uL to the water tube. Spin for 5 minutes at 10,000 rpm at 4 degrees C. This will cause the bacterial cells to collect in a pellet at the bottom of your tube.
7. Remove the supernatant without disrupting the bacterial pellets. Add 25 µL of ice cold 1x TSS buffer/tube (10uL for the water tube) and resuspend the cells by flicking the tube gently, then place the tubes on ice. [TSS buffer is LB with detergents and salts which will permeabilize cell membranes, allowing the plasmid to enter the bacterial cells].
8. Add 10µL (25ng) of ligated plasmid DNA to the cells in ligated plasmid group. Also add 25ng of empty vector to the cells in the empty vector tubes. Add 10uL of sterile water to the negative control tubes. Place back on ice. As you add these small volumes, mix gently with tip of your pipette.
9. Allow the cells to incubate for 40 minutes on ice. Do not mix the tubes during this incubation period.
10. After 40 mins, carry the ice bucket to a heat block pre-heated to 42 degrees and heat shock the cells for exactly 45 seconds, then immediately return the tubes to ice for 2 minutes. Add 250 ul of room temperature LB to each of your tubes.
11. Incubate your microcentrifuge tubes with cells in the large floor shaking incubator set to 37°C, on their side. Make sure tubes are completely shut.
12. After 60 minutes, plate cells. If you so choose, you can divide the volume of ~250µL LB/cells/DNA mixture into a plate of 10µL, 100µL, and the rest of the volume in order to see which volume grows the optimal amount of cells. Spread plates with sterile beads, and then pour used beads into white container with funnel (by the sink).